As much as we like the 5.9L Cummins powerplant, the stock exhaust manifold is constrictive and contorted, interfering with the flow of gases to the turbo and downpipe. That, in turn, can produce the cherry-red condition shown to the left. As a result, certain sections are prone to heat-induced cracks. Of course, one way to avoid that scenario is to make sure you have an EGT gauge and monitor it carefully when temperatures rise above 1,250 degrees Fahrenheit. Or for less obstructed flow (which lowers EGT and improves throttle response), ATS Diesel developed a multi-piece pulse exhaust manifold. Available for common rail, 12-, and 24-valve Cummins engines, it's designed to let the turbo spool up sooner with less exhaust backpressure and increase fuel efficiency. This pulse manifold design also eliminates the problems with shrinking and breaking, as well as cracking and gasket issues.
This is what you're trying to avoid. These areas on the factory Cummins manifold are subject to heat-induced cracking. Cracks lead to leaks, and leaks lead to lost turbo drive pressure and decreased engine performance.
The multi-piece design of the ATS manifold is joined together by ball-socket joints that are not only smoother in shape but also allow for expansion and contraction to prevent fracturing. A high-temp coating helps keep the surface temperature down as well.
A side-by-side comparison between the stock (top) and ATS manifold really shows the obvious differences in design. Note how much smoother the ATS shape is, with fewer restrictions that can build up heat and rob performance. The ATS bolt flanges are much beefier as well.
Installation of the new manifold begins with removing any pyrometer probes you may have added to monitor EGT and then unbolting the turbo, oil line, and any cooling lines that may be in the way. An air ratchet makes removing the factory bolts quicker once they are broken free.
There is a boss cast into the ATS manifold for a pyrometer probe, but you are required to drill and tap the hole yourself to ensure it is the proper size for your gauge.
We had Collins Diesel Injection install one of the ATS manifolds on our 12-valve truck in about half a day. We noticed two immediate benefits. The EGT was as much as 100 degrees cooler (depending on load factors and when used in conjunction with a Banks exhaust system), and the throttle response became noticeably quicker, with less foot pressure required to accelerate and maintain a given vehicle speed.